Spirit level

Installation Instructions

INSTALL THE RANGE

8 REPLACE THE WIRE COVER

Replace the wire cover on the range back by sliding its right edge under the retaining tab and replacing the two screws removed earlier. Make sure that no wires are pinched between the cover and the range back.

2 screws to

Retaining

replace wire

tab

cover

 

 

Wire

 

cover

Back of range

9 ANTI-TIP DEVICE INSTALLATION

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include all necessary information to complete the installation. Read the Safety Instructions and the instructions that fit your situation before beginning installation.

Bracket

Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall

WARNING:

Range must be secured by Anti-Tip bracket supplied.

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

See instructions to install (supplied with bracket).

Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury may result from spilled hot liquids or from the range itself.

10 LEVEL THE RANGE

AInstall the oven racks in the oven and position the range where it will be installed.

BCheck for levelness by placing a spirit level or a

cup, partially filled with water, on one of the oven

racks. If using a spirit level, take two readings—with the

level placed diagonally first

in one direction and then the other.

CThe rear leveling legs must be adjusted prior to moving the range into position. They can be adjusted from the bottom at the back of the range.

Adjust from

 

the bottom back

 

of range (warming

Raise

drawer models)

range

Leg leveler

Lower range

Back of range

DUse an open-end or adjustable wrench to adjust the leveling legs until the range is level.

EReplace the drawer or panel.

46

Page 46
Image 46
GE CS980SNSS installation instructions Replace the Wire Cover, ANTI-TIP Device Installation, Level the Range