Safety Instructions Operating InstructionsSafety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support
19
Care and cleaning of the range. GEAppliances.com

Be sure all controls are off and all surfaces are cool before cleaning any part of the range.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip

device is re-engaged properly when the range is replaced. Failure to take this

precaution could result in tipping of the range and cause injury.

How to Remove Packaging Tape

To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive left from packaging tape on
new appliances is an application of a
household liquid dishwashing detergent,
mineral oil or cooking oil.
Apply with a soft cloth and allow to soak.
Wipe dry and then apply an appliance
polish to thoroughly clean and protect
the surface.
NOTE: The plastic tape (on some models) must be
removed from all chrome trim. It cannot be
removed if it is baked on.

Control Knobs

To Remove:
Be sure the knob is in the OFF
position.
Pull straight off the stem. Using a
piece of string can make removing
the knob easier. Slip the string
under and around the knob,
pull straight out.
Wash the knob thoroughly with warm soapy
water. Dry completely with a soft cloth. DO NOT
let the knob soak.
To Replace:
Check the back of the knob.
The molded rib of the knob is
designed to fit perfectly onto the
knob stem.
Align the molded rib to the clear
groove in the knob stem. Push the
knob back as far as it will go.
Molded rib
Spring clip
Clear groove in
stem

Control Panel

■Clean up splatters with a damp cloth.
■You may also use a glass cleaner.
■Remove heavier soil with warm soapy
water.
■Do not use abrasives of any kind.

Storage Drawer Removal

To remove the drawer:
Pull the drawer out until it stops.
Lift the front of the drawer until
the stops clear the guides.
Remove the drawer.
To replace the drawer:
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and push
back until the stops clear the guides.
Lower the front of the drawer and
push back until it closes.
Stop guide
Rail