GE EGR2002 Consumer Support, Operating, Care and Cleaning, Installation, Safety Instructions

ge.com

Problem	Possible Causes	What To Do
Display goes blank	A fuse in your home may be	• Replace the fuse or reset the circuit breaker.
(on some models)	blown or the circuit
	breaker tripped.
	The clock is turned off so that it	• See the Using the clock and timer section.
	does not show in the display.
Display flashes	Power failure.	• Reset the clock.
(on some models)
Unable to get the	Oven control pads were	• The Bake and Broil Hi/Lo pads must be touched at
display to show “SF”	not touched properly.	the same time and held for 3 seconds.
(on some models)
Power outage,	Power outage or surge.	• Reset the clock. If the oven was in use, you must reset
clock flashes		it by touching the Clear/Off pad, setting the clock and
(on some models)		resetting any cooking function.
“Burning” or “oily” odor	This is normal in a new oven	• To speed the process, set a self-clean cycle for a
emitting from the vent	and will disappear in time.	minimum of 3 hours. See the Using the self-cleaning
		oven section.
Strong odor	An odor from the insulation	• This is temporary.
	around the inside of the oven
	is normal for the first few times
	the oven is used.
Fan noise	A cooling fan may automatically	• This is normal. The cooling fan will turn off and on.
	turn on and off to cool
	internal parts.
Drawer does not slide	The drawer is out of alignment.	• Fully extend the drawer and push it all the way in.
smoothly or drags		See the Care and cleaning of the range section.
	Drawer is over-loaded or load	• Reduce weight. Redistribute drawer contents.
	is unbalanced.

Safety Instructions
Instructions	Operating
Care and Cleaning
Instructions	Installation
Troubleshooting Tips

49

Consumer Support