GE JGBP33 Operating Instructions, Oven Air Vents, Care and cleaning of the range, Installation

Safety Instructions

Care and cleaning of the range.

Lift-Up Cooktop (on models with standard twin burners)

Clean the area under the cooktop often.	Clean under the cooktop with hot, soapy
Built-up soil, especially grease, may catch	water and a clean cloth. If you removed
on fire.	your surface burners while cleaning,
To make cleaning easier, the cooktop may	make sure they are properly seated when
	replacing them.
be lifted up.

Operating Instructions

Some models have dual support rods that will hold the cooktop up while you clean underneath it.

NOTE: Do not lift the cooktop on sealed burner models. Lifting the cooktop can lead to damage and improper operation of the range.

To raise the cooktop:

Be sure the burners are turned off.

Remove the grates.

Grasp the two front burner wells and lift up.

After cleaning, lower the cooktop (be careful not to pinch your fingers).

Care and Cleaning

Oven Air Vents

Never block the vents (air openings) of the range. They provide the air inlet and outlet that are necessary for the range to operate properly with correct combustion.

Vent appearance and location vary.

Air openings are located at the rear of the cooktop, at the top and bottom of the oven door, and at the bottom of the range, under the warming drawer, storage drawer or kick panel (depending on the model).

Lower Control Panel (Front Manifold Panel) and Knobs

Installation	Instructions
Troubleshooting Tips
Consumer Support

Pull the knob straight off the stem.

32

It’s a good idea to wipe the control panel after each use of the oven. Use a damp cloth to clean or rinse. For cleaning, use mild soap and water or a 50/50 solution of vinegar and water. For rinsing, use clean water. Polish dry with a soft cloth.

Do not use abrasive cleansers, strong liquid cleaners, plastic scouring pads or oven cleaners on the control panel—they will damage the finish.

Do not bend knobs by pulling them up or down or by hanging a towel or other such loads. This can damage the gas valve shaft.

The control knobs may be removed for easier cleaning.

Make sure the knobs are in the Off positions and pull them straight off the stems for cleaning.

The knobs can be cleaned in a dishwasher or they may also be washed with soap and water. Make sure the insides of the knobs are dry before replacing.

Replace the knobs in the Off position to ensure proper placement.

Metal parts can be cleaned with soap and water. Do not use steel wool, abrasives, ammonia, acids or commercial oven cleaners. Dry with a soft cloth.