5 | Measure the height of your cabinet opening. |
The top of the compactor should be at least | |
1/8″ (3 mm) from the top of the cabinet | |
opening. |
The rear wheels are preset for a cabinet opening height of
To adjust for other cabinet opening heights, loosen screw just enough to clear stud from hole in position “A”. Move the rear wheel and stud to position “B” or “C” as needed for your cabinet opening measurement:
Position B:
Position C:
Tighten screw. Repeat for other rear wheel.
Cabinet
A
C | B | Locating stud |
| ||
| Wheel bracket | |
|
| |
|
| assembly |
Safety Instructions Operating
6 | Use pliers to lower leveling legs away from cabinet. Adjust legs so there will be a 1/8″ (3 mm) | ||||
to 1/4″ (6.4 mm) space between the top of the compactor and the top of the cabinet opening. | |||||
Stand the compactor upright. | |||||
7 | Use pliers to lower leveling legs away from |
|
|
|
|
|
| ||||
cabinet. Place level inside on the floor of the |
|
|
|
| |
| |||||
cabinet. Check that the compactor is level |
|
| |||
from front to back and side to side. Adjust |
|
| |||
| the leveling legs until the compactor is level. |
|
| ||
|
|
|
|
|
|
8 | Determine if you want the compactor frame |
|
or drawer front flush with the cabinet front. | Retaining | |
| ||
Adjust the retaining brackets to the cabinet | bracket | |
top as needed: |
| |
| If the compactor frame is to be flush with the |
|
| cabinet front, place retaining bracket screws |
|
| through “A”. | Countertop |
| If the compactor drawer front is to be flush with | B |
| A | |
| the cabinet front, place retaining bracket | C |
| screws through “C”. |
If the compactor is to be midway between “A” and ”C”, place retaining bracket screws through “B”.
WARNING
Injury Hazard
When moving or lifting the compactor, use a glove to protect and cushion your hand.
More than one person is recommended to lift or move compactor because of its size and weight. Use proper lifting methods.
Failure to follow these instructions could result in injury.
13
Instructions Installation Instructions Troubleshooting Tips Consumer Support