Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions
Installation Instructions.
9 | Move the compactor close to its final position. |
|
|
Plug the power supply cord into a properly |
|
| |
grounded receptacle. |
|
| |
Carefully lift the front slightly and roll |
|
| |
| compactor into the cabinet opening until the |
|
|
| retaining brackets stop the unit. |
|
|
| Using the two #8 |
|
|
| retaining brackets to the underside of the |
|
|
| countertop with the mounting screws. If the |
|
|
| brackets cannot be attached to the underside | Lift here | |
| of countertop, attach mounting clips to |
|
|
| brackets. Fasten compactor to cabinet front |
|
|
| with mounting screws through mounting clips. |
|
|
Retaining bracket
Mounting screw
Retaining bracket
Mounting clip
Mounting screw
Grasp sides of compactor drawer and place bottom of drawer into tracks. Lift at the handle so
10 the front of drawer will go over drawer stops. Close drawer. Check if drawer opens freely. If the toe plate rubs against floor, see section below.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows:
1 Mark on each side of the toe plate the amount of toe plate that rubs the floor covering.
2 Remove the drawer from the unit. See Step 3.
3 Use a ruler and a pencil or chalk to draw a line between the marks on each side of toe plate.
4 Use scissors or utility knife to cut toe plate along line.
5 Replace drawer. See Step 10. If toe plate still rubs floor covering, repeat these steps.
14