Installation Preparation
2LEVELING THE COMPACTOR
•The top of the compactor should be at least 1/8″
(3 mm) from the top of the cabinet opening. You can adjust the height of the compactor by turning the screws on the front leveling legs and rear wheels.
Front leveling legs
Rear wheels
•Place a level inside the compactor on the floor of the cabinet.
•Use the leveling legs to adjust level front to back and side to side.
3ADJUST THE RETAINING BRACKET
•Determine installation depth of the compactor beneath the countertop.
•Adjust the position of the retaining brackets so that the screws can meet the underside of the countertop.
•Mounting clips are provided for stone or other hard countertops that will not accept screws.
Retaining bracket
Countertop
4 ADJUSTING THE BASE TOEKICK
A toekick extension is supplied. It can be used to cover any gaps from the bottom of the compactor to the floor.
•Remove the top toekick screws as shown. Lift off top toekick piece.
•Loosen the base toekick screws, adjust to touch the floor and tighten the screws.
•Reinstall the top toekick piece with the original screws.
Top toekick
|
| Loosen screw |
Adjustable |
| |
| on each side | |
lower toekick |
| |
|
| |
| ||
|
|
|
7