Installation Preparation
ELECTRICAL REQUIREMENTS
WARNING!
FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or adapter plug with this appliance.
•The power supply cord and plug should be brought to a separate 15 or 20 ampere branch circuit single grounded receptacle. The outlet box should be located within reach of the 36" (91.4 cm) power cord.
•This appliance must be supplied with 120V, 60Hz and connected to an individual properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse.
•If the electrical supply does not meet the above requirements, call a licensed electrician before proceeding.
IMPORTANT: Observe all governing codes and ordinances.
GROUNDING REQUIREMENTS
WARNING!
The improper connection of the equipment grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt that the appliance is properly grounded.
•Electrical Ground is REQUIRED on this compactor.
•DO NOT ground to a gas pipe.
•DO NOT change the power supply cord plug. If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
•DO NOT have a fuse in the neutral or grounding circuit. A fuse in the neutral or grounding circuit could result in an electrical shock.
•DO NOT use an extension cord with this compactor.
Failure to follow these instructions could result in death or serious injury.
Recommended Grounding Method:
For your personal safety, this appliance must be grounded. This appliance is equipped with a power supply cord having a
Power
supply Grounding
cordplug
Copies of the standards listed may be obtained from:
*National Fire Protection Association Batterymarch Park, Quincy, MA 02260
5