Dishwasher Installation
STEP 24: REPLACE TOEKICK
• Place toekick against the pre-toekick (on some models) and
legs of the dishwasher.
Figure AH

Attachment

Screws

Toekick

• Align the toekick with the bottom edge and make sure it is
DJDLQVWWKHÀRRU
• Insert and tighten the 2 toekick attachment screws. The
WRHNLFNVKRXOGVWD\LQFRQWDFWZLWKWKHÀRRU
• When reinstalling the toe kick on models with a sound barrier,
ensure that the bottom edge of the rubberized flap is flush
with the floor. Any excess material should be tucked up
behind the outer door. Do not allow excess rubberized flap to
lay on the floor. If any excess is not tucked completely behind
the outer door, it will bunch up between the door and toe kick
and impede proper opening and closing of the door. This will
be noticeable because the door will not stay fully open and
will spring up.
Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.
STEP 25: LITERATURE
• Be sure to leave complete literature package, these
Installation Instructions and product samples and/or coupons
with the consumer.
13
Sound
Barrier
STEP 23: POSITION INSULATION, PRE- TOEKICK, AND SOUND BARRIER
(on some models)
Skip this step if the sound insulation package is not supplied
with the dishwasher.
• Locate the sound insulation package and pre-toekick
packages inside the dishwasher.
• Stand the parts upright as shown.
• Locate the control box.
• Push insulation block portion under the dishwasher until it is
beneath the control box.
• Push the panel portion up to the front of the block.
• Tuck the sides of the front panel behind the toekick
attachment screw holes.
• Open door all the way, if the door doesn’t stay fully open,
adjust the insulation panel.
• On models so equipped, position pre-toekick over the
insulation. Align the screw holes with the screw holes on the
legs of the dishwasher.
Toekick Panel
(On some
models.)
Insulation
Block
(On some
models.)
Dishwasher
Door
Pre-
Toekick
(On some
models.)
Sound barrier
(On some
models. Part is
already attached
to door.)
Push the sides of the insulation behind
the toekick attachment screw holes
Figure AF
Control Box
Figure AG
Figure AH
• On models so equipped, remove the masking tape from the
sound barrier and door front. Position the sound barrier over
the insulation.