GFK-1852 Chapter 1 Introduction and Quick Start 1-5
Introduction and Quick Start 1
do not complete this procedure and have to come back to it at a later time,
you may have to start from the beginning.
C. Type the following at the prom p t, then press the Enter key:
arp –s (IPAddress you want the VMSE to have) ( Mac Address of VMSE)
This example uses: arp -s 3.16.27.44 00-20-4a-51-0e-5b
NOTE: You will not see any reply on the screen (see Figure 1-5).
D. Type telnet (IP Address) 1 (don’t forget the space between the IP address and
the 1), and then press the Enter key.
This example uses: Telnet 3.1 6. 27.44 1
This connection will fail, but the VMSE will change its IP address to the one
designated in the ARP command line. You should see the following screen after
a short time-out period:
Figure 1-4. Results of the Telnet 3.16.27.44 1 Command
E. Click the OK button in the “Conn ect F a iled” box, then close the “Telnet (Non e)”
box.
F. At the MS-DOS prompt, type Telnet (IP Address) 9999 (don’t forget the space
between the IP address and 9999), and then press the Enter key
This example uses: telnet 3.16.27.44 9999