Installation Preparation
PREPARE DISHWASHER ENCLOSURE
| This Wall Area |
| must be Free of |
| Pipes or wires |
24" |
•The dishwasher must be installed so that drain hose is no more than 10 feet in length for proper drainage.
•The dishwasher must be fully enclosed on the top, sides and back, and must not support any part of the enclosure.
Underside of | 5" | 4" | 5" | Min. |
|
4" |
| ||||
Countertop |
|
|
| ||
to Floor | Plumbing and Electric Service |
|
| ||
|
|
| |||
| Must Enter Inside This Area |
| Cabinets | ||
|
|
|
|
| |
|
|
|
|
| Square |
|
|
|
| 6" | and |
Figure A |
|
|
|
| Plumb |
| 24" |
|
|
| |
|
|
|
|
| |
Floor MUST be Even Min. |
|
|
| ||
With Room Floor. |
|
|
|
|
CLEARANCES: When installed into a corner, allow 2" min. clearance between dishwasher and adjacent cabinet, wall or other appliances. Allow
Countertop
Dishwasher
Clearance for Door Opening 2" Minimum
•The rough cabinet opening must be at least 24" deep, 24" wide and approximately
Figure B
DRAIN REQUIREMENTS
•Follow local codes and ordinances.
•Do not exceed 10 feet distance to drain.
Note: This dishwasher is equipped with a high drain loop. There is no minimum height required for drain hose routing. However, 18" minimum from floor to center of waste tee or disposer inlet is required. See Figure D.
DETERMINE DRAIN METHOD
The type of drain installation depends on the following question.
♦Do local codes or ordinances require an air gap?
♦Is waste tee less than 18" above floor?
If the answer to either question is YES, Method 1 MUST be used.
• If the answers are NO, either method may be used.
CABINET PREPARATION
•Drill a
IMPORTANT: When connect- |
|
|
|
|
|
| Remove |
|
|
|
|
| Hopper | ||
|
|
|
| ||||
ing drain line to disposer, check to |
|
|
|
| Plug | ||
|
|
|
|
be sure that drain plug has been removed. DISHWASHER WILL
NOT DRAIN IF PLUG IS LEFT IN PLACE.
Figure C
Method 1 – Air Gap with Waste Tee or Disposer
An air gap must be used when required by local codes and ordinances. The air gap must be installed according to manufacturers instructions.
18" | 18" |
Min. | Min. |
Figure D
Method 2 –
3