Installation Instructions
STEP 13 CONNECT WATER SUPPLY | Compression Nut |
Connect water supply line to 90° elbow. | Ferrule |
| |
• Slide compression nut, then ferrule over end of |
|
water line. | Hot Water |
• Insert water line into 90° elbow. | 90° Elbow Supply Line |
•Slide ferrule against elbow and secure with compres- sion nut.
IMPORTANT: Check to be sure that door spring |
|
does not rub or contact the fill hose or water supply |
|
line. Test by opening and closing the door. | Figure V |
lines if necessary. | 90° Elbow |
| Door Spring |
STEP 14 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8", 3/4" or 1" diameter connections on the air gap, waste tee or disposer. Cut on the marked line as required for your installation.
1"5/8"
IMPORTANT: Do not cut corrugated | Figure W |
portion of hose |
|
•If a longer drain hose is required, add up to 42" of length for a total of 10 ft. length to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with hose clamps.
DRAIN LINE INSTALLATION
•Connect drain line to air gap, waste tee or disposer using either previously determined method.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation | Disposer Installation |
Figure Y
Method 2 –
Hose Clamp
Coupler
Hose Clamp
Figure X
18"
Min.
Waste Tee Installation
18"
Min.
Disposer Installation
Figure Z
•Secure the drain hose to the air gap, waste tee or disposer with clamps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET FOR PROPER DRAIN OPERATION.
IMPORTANT: When connecting |
|
|
|
| Remove | ||
|
|
| |||||
drain line to disposer, check to be |
|
|
|
|
| ||
|
| Hopper | |||||
sure that drain plug has been |
|
|
|
|
|
| |
|
|
| Plug | ||||
removed. DISHWASHER WILL NOT |
|
| |||||
|
|
| |||||
DRAIN IF PLUG IS LEFT IN PLACE. |
|
|
|
9