Installation Instructions
STEP 17 DISHWASHER WET TEST
♦Turn on power supply (or plug power cord into outlet, if equipped).
♦Latch door.
♦Push “Normal Wash” button.
♦Push start/reset pad once.
♦Check to be sure that water enters the dishwasher. If water does not enter the dishwasher, check to be sure that water and power is turned on.
♦Check for leaks under the dishwasher. If leak is found, turn power supply off, then tighten connec- tions. Restore power after leak is corrected.
♦Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting against adjacent cabinetry. Reposition the dish- washer if necessary. See Step 12.
♦The dishwasher will drain about 5 minutes after the first fill. Check drain lines. If leaks are found, turn power off, correct as necessary. See Step 14.
♦Open dishwasher door and make sure most of the water has drained. If not, check that disposer plug has been removed and/or air gap is not plugged. See Step 14.
♦Let dishwasher run through another fill and drain cycle. Check again for leaks and correct as required.
♦At the end of the second drain, push the start/reset pad once. Wait for dishwasher to pump out and then unlatch the door.
STEP 18 REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
T | oekick |
|
Attachment Screws
FigureBB
•Align the toekick with the bottom edge and make sure it is against the floor.
•Insert and tighten the two toekick attachment screws. The toekick should stay in contact with the floor.
TIP: Make sure toekick is against floor to minimize noise.
STEP 19 LITERATURE
• Be sure to leave complete literature package and installation instructions with the consumer.
11
