Installation Instructions
STEP 3 REMOVE TOEKICK
• Remove the two toekick screws.
Toekick
Remove 2
Toekick Screws
Figure I
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or has a factory installed power cord.
The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances.
• Maximum power cord length is 6 feet.
A | C |
|
Remove | Insert Power |
|
Junction Box | Cord Wires Thru |
|
Cover | Strain Relief |
|
| and Tighten | White |
|
| |
| Ground | Black |
|
| |
B Check That White, Black and |
| |
Green Dishwasher Wires Are Threaded | D | |
Thru Small Hole in Bracket | ||
Figure J |
| Use UL Listed |
| Wire Nuts |
•Connect incoming power cord white (or ribbed) to dishwasher white, black (or smooth) to black and ground to dishwasher green wire. Use UL listed wire nuts of appropriate size.
•Replace junction box cover. Be sure wires are not pinched under the cover.
STEP 5 INSTALL 90° ELBOW
•Wrap 90° elbow with thread seal tape.
•Install a 90° elbow onto the water valve.
Front of Dishwasher
Water Valve
Bracket
90°
Elbow
Fill
Hose
Figure K
Thread Seal Tape
•Do not over tighten 90° elbow, water valve bracket could bend or water valve fitting could break.
•Position the end of the elbow to face the rear of the dishwasher.
STEP 6 POSITION WATER LINE AND HOUSE WIRING
•Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher.
4" | 5" | 5" | 4" |
|
| 4" |
|
6"6"
Water House
Line Wiring
Figure L
6