Installation Instructions
FAUCET INSTALLATION
Be sure there is room underneath the sink to make the needed connections. Select one of the following locations to install the faucet:
•In an existing sink spray attachment or soap dispenser hole.
•In a hole to be drilled in the sink top.
•In a hole to be drilled in the countertop, next to the sink.
NOTE: Be sure the faucet base will fit flat against the surface at the selected location so the gasket will seal.
1.If drilling is needed, make a
2.Insert the faucet spout into the body. Tighten cap until snug.
3.Feed the blue, 1/4″ black and 3/8″ black tubes up through the hole in the countertop or sink.
4.Feed the two black tubes up through the gasket, faucet base and
Spout
ASSEMBLED
Cap
Handle
Body
| |
| Base |
Mounting | Gasket |
| |
disk |
|
5.Push the 1/4″ black and 3/8″ black tubing onto their respective barb fittings on the body.
6.Seat the base and body together. Make sure the
7.Slide the lock washer onto the threaded stem of the body, then thread the brass nut onto the stem. Screw about halfway up.
8.Screw the tubing adapter to the threaded stem of the body.
9.Push the blue tubing into the adapter. It should go in about 1/2″. Pull on it to make sure it is installed securely.
10.Feed the tubing and stem back down through the
11.Under the counter, insert the mounting disk above the lock washer and tighten the brass nut until snug.
3/8″ barb |
|
fitting | ″ |
| 1/4 barb |
| fitting |
| Lock washer |
Black 3/8″ | Nut |
tubing, |
|
27″ long | Tubing adapter |
| |
Black 1/4″ |
|
tubing | Blue 3/8″ tubing |
|
Nut 
Lock washer
Tubing adapter
NOTE: For ease of service and maintenance, keep tubing lengths long enough so removal of the Reverse Osmosis system from under the sink is possible.
8
From RO
To drain From RO
