Catalog Number: RSEN-W12
Total Lighting Control
Line-voltage Wall Switch Occupancy Sensor
DESCRIPTION AND OPERATION
The RSEN-W12 is a self-contained motion-sensing lighting control which replaces a conventional wall switch for energy savings and convenience. Lights turn off automatically after a room is vacated.
Built-in sensors produce low intensity, inaudible sound and detect changes in sound waves caused by motion, such as walking into the room, reaching for a telephone, turning in a chair. The sensor does not respond to audible sound.
In the Automatic ON mode, the lights turn on automatically when a person enters the room. In the Manual ON mode, lights are turned on by pressing the touchplate on the switch. Modes can be changed by flipping the concealed switch under the touchplate. In either mode, lights will remain on as long as motion is detected in the room. When no motion is detected, the lights will turn off automatically after the pre-set time delay. Following this, a “grace period” of approximately ten seconds allows lights to be turned on again by motion.
At any time, lights may be turned off while the room is occupied by pressing the touchplate. The RSEN-W12 is fully self-resetting; lights turned off manually in Automatic ON mode will stay off while the room remains occupied. After the room is vacated and the preset time delay and grace period have elapsed, the lights will remain off until turned on automatically the next time someone enters the room.
The RSEN-W12 can be used with a standard toggle switch to split the lighting load for rooms that are wired for two switches as shown in the wiring diagram.
FEATURES
• Replaces a conventional wall switch
• For use in small rooms or offices up to 300 square feet
• One model for either 120 VAC or 277 VAC
• Choice of automatic ON or manual ON modes
• Separate time delay and sensitivity adjustments
• For indoor use only
Before proceeding, read the enclosed installation instructions. For GE TLC Service, call: 1-877-584-2685 (USA) or 1-800-661-619 (Canada).
Installation Instructions
IMRSEN-W12
