Catalog Number:
Emergency Service or Support (888) 852-2778
TROUBLESHOOTING
Emergency Manual ON
An override jumper is located underneath the touchplate. This jumper should remain in place at all times, except in the event of unit malfunction. Remove the jumper to bypass the sensor and turn the lights on.
LED Will Not Go On
Verify that the lighting circuit has power. Verify that the sensor is properly adjusted. Press the touchplate to turn on the lights manually. If the LED does not light, replace the
Lights Will Not Turn ON
•If the lights will not turn on automatically after someone enters the room, press the touchplate to see if lights will turn on. If so, the
•If set to Automatic ON mode, the sensor may have been overridden by someone pressing the touchplate; allow the
•If the lights do not turn on after pressing the touchplate, confirm that no other switches or equipment are interrupt- ing or bypassing power to the sensor or the load.
•If lights still do not turn on, replace the RSEN-W12.
Lights Will Not Turn OFF
•If lights will not turn off after the set time delay, and the LED has not lit during the time period, press the touchplate to turn off the lights manually.
•If lights turn off, refer to items 5 and 6 under “Checkout and Adjustment.”
•If lights do not turn off, verify that the override jumper under the touchplate has not been removed.
•Confirm that no other switches or equipment are interrupt- ing or bypassing power to the
•If lights still do not turn off, replace the RSEN-W12.
GE Lighting Controls, 41 Woodford Ave., Plainville, CT 06062
Made in U.S.A.
4