Safety Instructions
Care and cleaning of the range.
Painted Surfaces
Painted surfaces include the sides of the | Do not use commercial oven cleaners, |
range and the door, top of control panel | cleaning powders, steel wool or harsh |
and the drawer front. Clean these with soap | abrasives on any painted surface. |
and water or a vinegar and water solution. |
|
|
|
Instructions
Control Panel
It’s a good idea to wipe the control panel after each use of the oven. Use a damp cloth to clean or rinse. For cleaning, use mild soap and water or a 50/50 solution of vinegar and water. For rinsing, use clean water. Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid cleaners, plastic scouring pads or oven cleaners on the control panel— they will damage the finish.
Consumer Support Troubleshooting Tips Care and Cleaning Operating
Slot
Hinge 
lock
Pull hinge locks down to unlock.
Removal position
The gasket is designed with a gap at the bottom to allow for proper air circulation.
Do not rub or clean the door
If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.
26
Lift-Off Oven Door
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small flat- blade screwdriver, may be required.
Firmly grasp both sides of the door at the top.
Close door to the door removal position, which is halfway between the broil stop position and fully closed.
Lift door up and out until the hinge arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door at the top.
With the | Bottom | Hinge arm | |
door at the | edge | ||
| |||
same angle as | of slot |
| |
the removal |
|
| |
position, seat the |
| ||
indentation of |
| Indentation | |
the hinge arm |
| ||
|
| ||
into the bottom |
| ||
edge of the hinge slot. The notch in | |||
the hinge arm must be fully seated | |||
into the bottom of the slot. | |||
Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.
Push the hinge locks up against the front frame of the oven cavity to the locked position.
Hinge 
lock
Hinge 
arm
Push hinge locks up to lock.
Close the oven door.
To clean the inside of the door:
■Do not allow excess water to run into any holes or slots in the door.
■Because the area inside the gasket is cleaned during the
■The area outside the gasket and the door liner can be cleaned with a
To clean the outside of the door:
■Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door. Do not let water drip into the vent openings.
■If any stain on the door vent trim is persistent, use a soft abrasive cleaner and a
■Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse.
■Do not use oven cleaners, cleaning powders or harsh abrasives on the outside of the door.
