Installation
Stainless Steel Interior Dishwasher
Step 8
Install
Drain Line
•Follow all local codes and ordinances.
Drain Line Preparation
•The dishwasher is supplied with a 78” long corrugated drain hose.
•If the location requires a longer drain hose, add up to 42” length to the supplied hose. Use 3/4” inside diameter hose and thin wall copper coupler to join the hose ends.
Note: Total drain hose length must not exceed 10 feet for proper drain operation.
Method 1 – Air Gap with Waste Tee or Disposer
Waste Tee Installation | Disposer Installation |
Method 2 – High Drain Loop
with Waste Tee or Disposer
Drain Line Installation
•Connect drain line to air gap, waste tee or disposer using either method 1 or 2 as previously determined.
•Secure connection using appropriate clamps (not supplied).
•Make sure drain hose is not kinked.
Note: Remove drain plug before connecting to disposer. Dishwasher cannot drain if plug is left in place.
Fasten to underside | Fasten to underside | |
of countertop | ||
|
| of countertop |
| 30" | 30" |
12" | Min. | |
| 12" Min. | |
Min. |
| |
| Min. | |
|
| |
Waste Tee Installation | Disposer Installation |
Step 9
Connect
Electrical
(For direct connection to house wiring)
WARNING If house wiring is not
by the installer. When house wiring is aluminum, be sure to use U.L. listed
AVERTISSEMENT
Si le circuit de la maison n’a pas deux |
| |
fils, plus un fil de terre, l’installateur |
| |
doit installer un fil de terre. Quand les |
| |
fils de la maison sont en aluminium, il | Screw F | |
faut prendre soin d’utiliser une pâte | ||
| ||
| ||
aluminium à cuivre sur la liste UL. |
|
Verify that power is turned off at the source.
•Install a strain relief onto the junction box and tighten against the incoming wires.
•Strip 1/2” insulation from end of incoming wires.
•Use wire nuts of appropriate size and con- nect white to white, black to black and incoming ground to green wire.
•Push all wires into the junction box and place on dishwasher frame. Secure with screws “F”.
13