Step 3
Install
Water Inlet
Fittings
Step 4
Install power cord
(If used)
Skip this step If dishwasher will be wired direct.
Installation
Stainless Steel Interior Dishwasher
•Install the 90° elbow onto the water inlet. Use thread sealing tape or pipe thread compound.
•The 90° elbow should face the left or right side, depending on water line routing.
•Install strain relief onto junction box and tighten against incoming wires.
•Strip 1/2” insulation from end of power cord wires.
• Connect incoming wires to dishwasher wires using wire nuts of appropriate size.
• Connect the white to white, black to black and incoming ground to green wire.
• Push all wires into the junction box and secure cover with screws onto dishwasher frame.
Note: The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances.
IMPORTANT: The power cord must be no longer than 6 ft from the junction box to the plug. DO NOT PLUG IN POWER CORD AT THIS TIME.
Screw F
11