Install Custom Door Panel
Step 1
Remove wood base
Step 2
Install leveling legs
&toekick
brackets
Installation
Stainless Steel Interior Dishwasher
•If you intend to install custom door panels, refer to installation instructions provided in this booklet. The panels should be in place before installing the dishwasher.
Cut the shipping carton and use it as a pad under the dishwasher. This will protect the finished floor in the kitchen.
•Lay the dishwasher on its back.
•Remove the 4 screws holding the dish- washer to the wood base. Discard screws.
•Retain wood base.
•Insure that the floor of the cutout is the same level or higher than the rest of the room. If the kitchen floor is tile, it may be elevated above the floor of the installation cutout. Pieces of the wood base may be
placed into the cutout floor to make it level |
|
| |
or higher than with the kitchen floor. This |
|
| |
|
|
| |
will allow for easy removal for any future |
|
|
|
service. |
|
|
|
•
• Install toekick support brackets on the left and right sides of the mounting brackets using 2 screws each. See illustration for correct orientation.
•Install the front leveling legs provided in the parts package. The legs should be at least 2” from the bottom edge of the mounting bracket.
•Adjust leveling legs to installation height. Tighten leveling leg locking nuts on the
rear.
2" Min.
Screw C | Mounting Bracket |
|
Toekick Support Bracket
10
