Installation Preparation
Stainless Steel Interior Dishwashers
Power Supply
WARNING | FOR PERSONAL SAFETY: | |
REMOVE HOUSE FUSE OR OPEN | ||
| ||
| CIRCUIT BREAKER BEFORE BEGINNING | |
| INSTALLATION. |
DO NOT USE AN EXTENSION CORD OR
ADAPTER PLUG WITH THIS APPLIANCE.
FOLLOW NATIONAL ELECTRICAL
CODES OR PREVAILING LOCAL CODES
AND ORDINANCES.
AVERTISSEMENT
SÉCURITÉ
IL FAUT ENLEVER LE FUSIBLE DE LA
MAISON OU OUVRIR LE DISJONCTEUR
AVANT DE COMMENCER
L’INSTALLATION.
IL NE FAUT PAS UTILISER DE
18"
Receptacle
18" Location
Area
6" 6"
Alternate
Receptacle
Location
3"
2"Cabinetfrom
2" 24" from Wall
Ground
Black
White
RALLONGE NI D’ADAPTATEUR DE FICHE AVEC CET APPAREIL. IL FAUT RESPECTER TOUS LES CODES D’ÉLECTRICITÉ NATIONAUX OU LES CODES ET RÈGLEMENTS LOCAUX EN VIGUEUR.
Electrical Requirements:
These dishwashers must be supplied with a 120 volt, 60 Hz power supply with an indi- vidual, properly grounded branch circuit, protected by a 15 or 20 amp fuse or circuit breaker or time delay fuse.
•Wiring must be 2 wire with ground.
•If electrical supply does not meet the above requirements, call a licensed electrician before proceeding.
Grounding Instructions:
This appliance must be either connected to a
Cabinet Preparation & Wiring:
•Wiring may enter from either side, the rear, or from the floor within the shaded area shown.
•Cut hole
Electrical Connections:
The electrical connection is on the right side of the dishwasher.
•For cable direct connections, the cable must be routed as illustrated. The cable must extend forward a minimum of 24” from the rear wall.
•For power cord connections, install a
•Allow approximately 3” between cable and adjacent cabinetry.
WARNING
THE IMPROPER CONNECTION OF THE EQUIPMENT - GROUNDING CONDUCTOR CAN RESULT IN A RISK OF ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE REPRESENTATIVE IF YOU ARE IN DOUBT WHETHER THE APPLIANCE IS PROPERLY GROUNDED.
AVERTISSEMENT
LE MAUVAIS BRANCHEMENT DU CONNECTEUR DE MISE À LA TERRE DE L’ÉQUIPEMENT PEUT CAUSER UN RISQUE D’ÉLECTROCUTION. EN CAS DE DOUTE SUR LA MISE À LA TERRE DE L’APPAREIL, CONSULTER UN ÉLECTRICIEN QUALIFIÉ OU UN PRÉPOSÉ DE SERVICE.
8