GE ZBD5900, ZBD5700 Step Remove Existing Metal Door Step Assemble, ZPF25 Custom Door Panel Kit

Step 2

Remove

Existing

Metal Door

Step 3

Assemble

Panel to

Door

Step 4

Install Door

Center

Bracket

ZPF25 Custom Door Panel Kit

1/4" Thick Custom Door Panel

• Open the door fully.

Caution: One person should hold the door while the other backs out screws to prevent the metal door from falling.

•Remove 6 screws on the inside the inner door frame. Retain screws.

•Remove the 2 screws with o-rings located in the bottom center of the inner door. Retain screws and o-rings.

•Remove the outer door.

•Remove the 2 screws holding the center door bracket to metal door.

•Retain bracket and insulation.

•Discard metal door.

• Place the supplied metal door on a flat	Decorative Panel
surface.	Door Trim

•Place the custom panel on top of the metal door.

•Place supplied trim over the custom panel.

•Press trim to panel and install the color matched screws provided. Install 3 screws on each side and 2 screws on the bottom.

Door Panel

• Turn the assembled door over with appear-	Insulation
ance side down.
• Install center door bracket onto door using
original screws.
• Place insulation around support bracket.

Install Screws

17