Step 7
Install
Custom
Toekick
ZPF75 Custom Panel Kit
3/4" Thick Custom Door Panel
•Slip toekick slides into guides by pulling out the metal tabs.
•Hold custom panel against toekick slides and mark screw hole locations.
•Remove toekick and drill 1/8" pilot holes.
•Remove toekick slides and secure panel to slides with 2 screws each. Use screws “X”. If panels are 1/2" thick, use caution when
driving these screws.
•Insert the assembled toekick into the support brackets by pulling out the metal tabs.
•Carefully, slide assembly back until it is aligned with adjacent cabinetry toekick.
• See product installation instructions to reinstall the dishwasher.
• Carefully, hold the door and open fully.
Insure that door does not strike top of | Screw X | Pull Tab While Pushing toekick in | |
toekick. | |||
|
22
