Cleaning the glass cooktop. | GEAppliances.com |
Control Lockout (on some models)
Begin by locking the cooktop; see the Control Lockout section.
Safety Instructions
Clean your cooktop after each spill.
Normal Daily Use Cleaning
ONLY use the recommended cleaning cream, Cerama Bryte®, on the glass cooktop. Other creams may not be as effective.
To maintain and protect the surface of your glass cooktop, follow these steps:
Before using the cooktop for the first time, clean it with the cooktop cleaning cream. This helps protect the top and makes
Daily use of the cooktop cleaning cream will help keep the cooktop looking new.
Shake the cleaning cream well. Apply a few drops of the cream directly to the cooktop.
Use a paper towel or sponge to clean the entire cooktop surface.
NOTE: It is very important that you DO NOT heat the cooktop until it has been cleaned thoroughly.
Operating Instructions Care
Burned-On Residue
WARNING: DAMAGE to your glass surface may occur if you use scrub pads other than BLUE
Allow the cooktop to cool.
Spread a few drops of Cerama Bryte® to the entire burned residue area.
Using the
If any residue remains, repeat the steps listed above as needed.
For additional protection, after all residue has been removed, polish the entire surface with Cerama Bryte® and a paper towel.
and Cleaning Troubleshooting
The RAZOR SCRAPER is available through our Parts Center. See instructions under “To Order Parts” section on next page.
NOTE: Razor blade is packed inverted for safety reasons. Prior to use, the blade must be rotated and reinserted into slot. Do not
use a dull or nicked blade.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Spread a few drops of Cerama Bryte® to the entire burned residue area.
Hold the razor scraper at approximately a 45° angle against the glass surface and scrape the soil. It will be necessary to apply pressure to the razor scraper in order to remove the residue.
Keep a small amount of cream on the residue as you scrape.
After scraping with the razor scraper, use the
For additional protection, after all residue has been removed, polish the entire surface with Cerama Bryte® and a paper towel.
Tips Consumer Support
31
