GE JBP70 Care and cleaning of the range, Care and Cleaning, Tips Consumer Support, Control Knobs

Models: EER3000 JBP70 EER2000 JBP64 JBP65 JBP78 JBP66

1 32
Download 32 pages 23.43 Kb
Page 19
Image 19
Care and cleaning of the range.

Care and cleaning of the range.

www.GEAppliances.com

Be sure all controls are off and all surfaces are cool before cleaning any part of the range.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device is re-engaged properly when the range is replaced. Failure to take this precaution could result in tipping of the range and cause injury.

Safety Instructions

How to Remove Packaging Tape

To assure no damage is done to the finish of the product, the safest way to remove the adhesive left from packaging tape on new appliances is an application of a household liquid dishwashing detergent, mineral oil or cooking oil.

Apply with a soft cloth and allow to soak. Wipe dry and then apply an appliance polish to thoroughly clean and protect the surface.

NOTE: The plastic tape (on some models) must be removed from all chrome trim. It cannot be removed if it is baked on.

Operating Instructions

Molded rib

Clear groove in

 

stem

 

Spring clip

Control Knobs

To Remove:

Be sure the knob is in the OFF position.

Pull straight off the stem. Using a piece of string can make removing the knob easier. Slip the string under and around the knob, pull straight out.

Wash the knob thoroughly with warm soapy water. Dry completely with a soft cloth. DO NOT let the knob soak.

To Replace:

Check the back of the knob.

The molded rib of the knob is designed to fit perfectly onto the knob stem.

Align the molded rib to the clear groove in the knob stem. Push the knob back as far as it will go.

Care and Cleaning

Control Panel

Clean up splatters with a damp cloth.

Remove heavier soil with warm

You may also use a glass cleaner.

soapy water.

Do not use abrasives of any kind.

 

Troubleshooting

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Rail

Stop guide

 

 

 

 

Storage Drawer Removal

To remove the drawer:

Pull the drawer out until it stops.

Lift the front of the drawer until the stops clear the guides.

Remove the drawer.

To replace the drawer:

Place the drawer rails on the guides.

Push the drawer back until it stops.

Lift the front of the drawer and push back until the stops clear the guides.

Lower the front of the drawer and push back until it closes.

Tips Consumer Support

19

Page 19
Image 19
GE JBP70 Care and cleaning of the range, Care and Cleaning, Tips Consumer Support, Operating Instructions, Control Knobs