Installation Instructions
Electrical Connections cont.
NEW CONSTRUCTION AND FOUR | |
WIRE CORD CONNECTION KIT |
|
Complete 4 wire
cord kit. Below are 3Screws
Gound
step by step_Screw and instructions on
Attach the green lead below the junction block with the ground screw that was removed earlier.
Connect the red
_rGround
ew
how to install the kit.
Location
and black leads to the outside
Relief
ConnectionClamp
Plate
terminals and the white lead to the center terminal.
Black White
Remove the screws on the terminal block with a 1/4" nut driver or phillips screwdriver.
Remove the ground screw using a 5/16" nut driver, then remove and discard
the ground strap. Do not discard the
ground screw, you will need it later.
[_1
r_
Ground
re\,:__Sc CGroun d
(Green)
Red or
Black
Push the cord upward (to relieve strain), while tightening the strain relief clamp.
wires do not become pinched between the wire cover and mainback.
Wi re
Cover
i
Install the
relief through the hole in the connection plate.
4 wire
cord kit
Connection
Plate
Strain
Relief
Clamp
6Three-wire connection continued on following page