GE JBP79 installation instructions Installing the Anti-TipBracket, El Locating The Bracket, Plate

Installation Instructions

Installing the Anti-Tip Bracket

El Locating The Bracket

The anti-tip bracket, provided with your literature and broiler pan, must be properly installed to prevent the range from tipping. Please refer to

the instructions provided with your anti-tip bracket.

a. Decide whether the bracket will be installed on the right or left side of range location.

b. If the bracket side of the range has an adjacent cabinet, place the bracket against the back wall and cabinet as shown in Fig. 1. If there is a countertop overhang, offset the bracket by the amount of overhang. If there is no adjacent cabinet, place the bracket to the

outside edge of the range side panel and back wall.

[_ ornstallingConcreteThe Bracket in Wood

INSTALLATION-WOOD CONSTRUCTION

a. Locate the centers of the four holes identified in Fig. 1 as Floor-Wood and Wall.

b. Drill a 1/8" pilot hole through the pre-marked areas. Note the angle of the wall screw in Fig. 2.

c. Mount the Anti-Tip bracket with the four screws provided.

Attachment To Wall

Bracket		Wall
_t_ ii i	_	Plate
IIIIIIIIIIIIIIIII!111!111111111_,111111111!11,		/111
	Screw Must		Fig. 2
	EnterWood

Adjacent	Cabinet
Or Final Location
Of Range	Side Panel	Wall

Side

Rear

LevelingFloor-Concrete Leg

Fig. 1

Or Metal

INSTALLATION-CONCRETE CONSTRUCTION

a. For concrete installation you will need two 1/4"x 1-1/2" lag screws, and two sleeve anchors.

b. Locate the center of the four holes identified in Fig. 1 as Floor-Concrete and Wall. Drill the recommended size holes in each.

c. Install the sleeve anchors into the predrilled concrete holes and install the lag and wall screws through the Anti-Tip bracket. Make sure the screws are securely tightened.