Control Panel and fiobs
Clean up any spills or spattem with a damp cloth. Remove heavier soil with warm, soapy water.
Clean control panel with mild liquid dish detergent and a soft cloth. Rub wntrol panel lightly.
CA~ON: Do not use abrasives of any kind on the control panel.
The control knobs may be removed for easier cleaning. To remove a knob, pdl it straight off the stem. Wash the knobs in soap and water but do not soak.
Lifi-Up CooMop
Clean the area under the cooktop often.
To make cleaning easier, the entire cooktop may be lifted up and supported in the up position.
Be sure W surface units are turned off before raising the cootip. Grasp the front sides of the cooktop and lift. me surface units and .?tiD Dans do not ne~d to be removed before raising :tie ‘~oktop, however, you may remove one to make raising the cooktoD. easier.
To lifi the cooktop:
1.Remove dl items which may slide off the cooktop.
2.With both hands, grasp the front edge of the cooktop.
3.Lift the cooktop.
4.Raise the support rod and let the cooktop rest on it.
Clean under the coo~p with ho~ mild soapy water and a clean cloth.
To lower the cootip:
1.Lift the cooktop and lower the support rod
2.Lower the moktop and allow it to lock into position.
Cleaning Under the Mnge
The area under the range can be reached eastiy for cleaning by removing the bottom drawer.
To remove, pull the drawer out dl the way, tilt up the front and remove it. To replace, insert @ides at the back of the drawer beyond the stop on range @ides. Lift the drawer if nwssary to insert easdy. tit the front of the drawer down, then push in to close.
~1+ 1 ‘ “ 1
&
Backplash Light
Press the backsplash light switch for ON. Press again for O=.
To replace the light Iomted in the backsplash:
1.If the light cover has screws, remove the four “ screws that hold it in position. Two are located on top of the backsplash and two are Ioated under the backsplash overhang.
2.If there are no screws or after they are removed lift the cover away and twist out the fluores%nt light.
CA~ON: Be sure the light is cool before removing.
3.Insert the new fluorescent light and twist into the lock position. (Check to make sure the new light operates. If no~ the light maybe blown.)
4.Replace the backsplash cover and reinsert the screws that hold it into position (on some models).
(conthwdtipage)
27
