2.Mconnectingto a four-wire electrical system (mobile home):

A Remove the screws and tise the terrnind block cover.

B. Remove the ground strap born the terminal block and from the apptiance frame. Reti the ground screw.

C. Connect the ground wire been) of the copper power supply cord to the frame of the apptiance with the ground screw, using the hole in the frame where the ground strap was removed. %e F~e 2.

D. Connect the neuti (white) wire of the copper power supply cord to the center sflver colored terrnind of the terrnind block and connect the other wires to the outer teds.

E. Replace the terrnind block cover.

FIGURE 2

CORD.

 

J

32

To ehate the hward of reaching overheated surface elements, mbinets or storage spaces should not be provided over a range.

Hcabinets are provided, the h-d can be reduced by insfig a rmge hood that projects hotiontiy a minimum of 5“ beyond the botiom of the cabinets.

men ins~g the range between base cabinets, refer to figure below for the ske of the opening needed. Do not sed the range to cabinets.

CA~ON: men unpacking the range, do not &scard the 4 shipping bolb as these are the levehg legs.

Ha service cord is used, the wd receptacle should be located in accordance with the dimensions below.

~ Of Range 1

I

 

I

\

\

 

Wall

\

~

2

=’‘~<*Note2

Dtiided Cootiop (40” Range)

Page 32
Image 32
GE JCP67 manual =’‘~*Note2