CONTROL PANEL ACCESS
FLIP PANEL UP TO ACCESS
FLUORESCENT LIGHT
A
HINGED ON
BACK SIDE
REMOVE 2 SCREWS
TO REMOVE CRYSTAL
END | SIDE |
CAP | FRAME |
|
TO REMOVE CONTROL PANEL
1. Grasp the light panel cover at the rear, |
where it is hinged to the control panel. Lift |
upward at the rear, just far enough to insert |
a small, thin bladed screw driver between |
the end cap and the fluorescent light cover. |
Slide the blade forward toward the front |
while lifting upward on the cover. Be sure to |
wrap the blade of the screw driver with tape |
so as not to scar the plastic shield. |
2. Remove screws A & B, which secure the |
endcaps to the control console. Be careful |
when removing the endcap not to break the |
locating tab at the bottom of the endcap. |
B
BE SURE TAB IS
IN SLOT WHEN
REINSTALLING
VENT DEFLECTOR 
Pull control panel down and forward to release it from the vent deflector
C
LOOSEN THIS SCREW TO RAISE CONTROL PANEL
3. LOOSEN screw C . DO NOT REMOVE. |
This screw is just long enough that it will |
protrude into a slot in the side frame, |
causing the panel to bind as you slide it |
down and forward. Loosening the screw a |
couple of turns will back it off enough that it |
will no longer protrude into the side frame |
slot. |
4. Grasp the face panel at the bottom front with |
one hand, while gently pushing down on the |
top of the control panel with your other. Pull |
panel downward to release it from the vent |
deflector while at the same time pull the |
REINSTALLING CONTROL PANEL
When reinstalling the control panel, push up on the vent lip with your fingers. At the same time pull forward on the control panel, making sure that the vent lip is TUCKED UNDER the control panel while lowering the panel into place.
TUCK VENT LIP UNDER CONTROL
PANEL PRIOR TO LOWER PANEL
LOWER PANEL
INTO PLACE
PUSH UP ON
VENT LIP
SPARK MODULE
The spark module is located behind the control panel, on the right side. You must remove the control panel to access the spark module.
BALLAST | SPARK |
MODULE |
TABS
– 13 –
