Instructions
Care and cleaning of the cooktop.
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety
Use a sewing needle or
Burner Caps and Heads
NOTE: Before removing the burner caps and heads, remember their size and location. Replace them in the same location after cleaning.
Burner caps
Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove
Burner heads
For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire
The slits in the burner heads must be kept clean at all times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.
Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.
You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. Lift off when cool.
To remove
After cleaning
Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes.
NOTE: Do not use steel wool or scouring powders to clean the burners.
Replacement
Replace burner heads over the electrodes on the cooktop, in the correct locations according to their size.
Medium head | Small head | Small head |
|
Front of cooktop
Medium head | Large head |
Make sure the slot in the burner head is positioned over the electrode.
Replace the matching size caps onto the heads. There is one large, two small and two medium caps.
Medium cap | Small cap | Small cap | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Front of cooktop
Medium cap | Large cap |
Make sure that the heads and caps are replaced in the correct locations.
10
