GE JGRP16 warranty To Set the Oven for Cleaning

1“ v to Set the Oven for Cleaning

Quick Reminder:

1.Prepare the oven for cleaning.

2.Close the oven door completely.

3.Press the CLEAN pad.

4.Press the INCREASE or DECREASE pad until the desired Clean Time appears.

If the oven is too hot and you start to set a clean cycle, the word “OFF” will appear in the display. Allow additional time for cooling before you try to

set the cycle.

1. Follow directions to prepare the oven for cleaning. n 2. Press the CLEAN pad.

CLEAN

3. Press the INCREASE or

A DECREASE pad until desired

~ Clean Time is displayed.

The Clean Time is normally 3 hours. You can change the Clean Time to anytime between 2 and 4 hours, depending on the amount of soil in your oven.

The self-clean cycle will automatically begin after “CLEAN” is displayed and the time for the clean cycle is set. The words “ON” and “LOCK” will appear in the display when the door automatically locks. It will not be possible to open the oven door until the temperature drops below the lock temperature ;nd the LOCK light goes off.

4.When the LOCK light is off, open the door.

NOTE: You can find out when the

DSTOP clean cycle will be finished by pressing

TIME the STOP TIME pad.

The word “door” will be displayed, the word “LOCK” will flash and oven control will signal if you set the clean cycle and forget to close the oven door.

-—

To Stop a Clean Cycle

1.Press the CLEAWOFF pad.

CLEAR

w

n

2.Wait until the oven has cooled below locking temperature. You will not be able to open the door right away unless the oven has cooled below the locking temperature.

(continued next page)

19