Installation Instructions
INSTALL THE RANGE (CONT.)
19ALTERNATE CONSTRUCTION PREPARATION (cont.)
DFOR CABINET OPENINGS APPROXIMATELY 30-3/8″
If range is installed in cabinet opening approximately
ECABINETS OVER THE RANGE LESS THAN 30″
If a 30″ clearance between cooking surface and overhead combustible material or metal cabinets cannot be maintained, protect the underside of the cabinets above the cooktop with not less than 1/4″ insulating millboard covered with sheet metal not less than 0.0122″ thick.
20OPERATION CHECKLIST
•Double check to make sure everything in this guide has been completed. Rechecking steps will ensure safe use of the cooktop.
•Make sure all controls are left in the OFF position.
•Make sure the flow of combustion and ventilation air to the cooktop is unobstructed.
•The serial plate for your Range is located under the oven door above the storage area. In addition to the model and serial numbers, it tells you the ratings of the burners and the type of fuel and pressure the cooktop was adjusted for when it left the factory.
•When ordering parts, always include the serial number and model number to ensure proper replacement parts.
•Recheck Steps: Double check to make sure everything in this guide has been completed. Rechecking steps will ensure safe use of the Range.
Please see L.P. conversion instructions supplied with this range when L.P. Gas is used.
NOTE: Instructions are mounted on regulator bracket.IN SOME CASES
AWith L.P. gas, some yellow tipping on the outer cone is normal.
BForeign particles in the gas line may cause an orange flame at first, but this will soon disappear.
SPECIAL NOTE:
To convert the oven back to natural gas, reverse the instructions given in making L.P. Adjustments.
Once the conversion is complete and checked ok, fill out the LP sticker and include your name, organization and the date the
conversion was made. Apply the sticker near the regulator to alert others in the future that this appliance has been converted to LP gas. If converting back to natural gas from LP, please remove the sticker so others know the appliance is set to use natural gas.
ADJUSTING LOW FLAME SETTING ON COOKTOP BURNERS
Low setting adjustments must be made with two other burners in operation on a medium setting. This procedure prevents the low flame from being set too low, resulting in the flame being extinguished when other burners are turned on.
ARemove the valve control knobs.
BThrough the opening, locate the valve bypass screw located on the lower right side of the valves.
CUsing a small screwdriver, screw down the bypass screw fully in a clockwise rotation.
16 | Printed in the United States |