Installation Instructions
INSTALLING THE COOKTOP
11INSTALLING THE HOLD-DOWN RETAINERS
NOTE: Check for glass flatness in Step 10 before installing
Hold- down retainer
Countertop
Thumb screw
Secure cooktop to the counter using the
12INSTALLING THE BLOWER PLENUM TO THE COOKTOP
Slide the plenum, with the blower opening on the left, into the opening in the bottom of the cooktop. Push up on the plenum until the stops on the plenum contact the bottom of the cooktop, and snap the plenum into place. (You may have to move the plenum back and forth to work it into place.)
Secure the plenum to the bottom of the cooktop, on each side, using the four (4) screws provided. Further secure the plenum to the cooktop, from the top side, using the two screws (2) provided.
13INSTALLING THE BLOWER TO THE PLENUM
Orient the blower discharge opening to match the ductwork in Steps 6 and 7. Slide the four threaded studs on the side of the blower housing into the four holes on the side of the plenum.
NOTE: See Step 14 for installing the transition duct to the blower. It may be easier to install the transition duct to the blower before installing the blower to the plenum.
From the vent opening in the top of the cooktop, fasten the blower assembly securely to the plenum with four (4) nuts.
4 Nuts (7/16″ socket required)
23