GE JP989SKSS owner manual 15CONNECTING THE DUCTWORK, 14ATTACHING A BLOWER TRANSITION DUCT

Installation Instructions

INSTALLING THE COOKTOP

14ATTACHING A BLOWER TRANSITION DUCT

Use a blower transition duct for all downward duct installations to connect to 6″ round standard ductwork. This 31⁄4″ x 10″ rectangle to 6″ round transition duct is available at your local building supply store.

Screw

(on other

side)

Screws

Remove the cardboard packing in the blower outlet.

Install the transition duct to the blower outlet. Secure all joints with duct tape to assure an airtight seal.

15CONNECTING THE DUCTWORK

Connect the ductwork prepared in Steps 5 and 6 to the blower transition duct.

16BLOWER ELECTRICAL CONNECTIONS

•Loosen the screws and remove and discard the sheet metal strap covering the 5-pin connector. Save the screws for reinstallation later.

•Connect the 5-pin plug on the blower assembly to the matching 5-pin receptacle on the bottom of the wire enclosure.

5-pin connectors

•Fold all wires into the electrical enclosure. Secure the enclosure with the screws removed earlier, making sure that no wires are trapped.

5-pin connectors

Electrical

enclosure

Flexible conduit

24