GE JRP20 Using the clock and timer, Support, Consumer, Care and, Cleaning Troubleshooting Tips

Models: JRP20

1 28
Download 28 pages 4.25 Kb
Page 9
Image 9
Using the clock and timer.

Using the clock and timer.

Not all features are on all models.

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a delayed cooking or a delayed self-cleaning cycle.

Touch the TIMER/CLOCK pad twice.

Touch the + or pad.

If the + or pad is not touched within one minute after you touch the TIMER/CLOCK pad, the display reverts to

the original setting. If this happens, touch the TIMER/CLOCK pad twice and reenter the time of day.

Touch the START pad until the time of day shows in the display. This enters the time and starts the clock.

To check the time of day when the display is showing other information, simply touch the CLOCK pad. The time of day shows until another pad is touched.

Instructions Operating Instructions

To Turn Off the Clock Display

If you have several clocks in your kitchen, you may wish to turn off the time of day clock display on your oven.

Touch the TIMER/CLOCK pad once to turn off the time of day display. Although you will not be able to see

it, the clock maintains the correct time of day.

Touch the TIMER/CLOCK pad twice to recall the clock display.

Care and
To Set the Timer

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

Touch the TIMER/CLOCK pad.

Touch the + or pad until the amount of time you want shows in the display. The maximum time that can be entered in minutes is 59. Times more than 59 minutes should be changed to hours and minutes.

The timer is a minute timer only.

The CLEAR/OFF pad does not affect the timer.

If you make a mistake, touch the TIMER/CLOCK pad and begin again.

Touch the START pad. The time will start counting down, although the display does not change until one minute has passed.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the TIMER/CLOCK pad is touched.

Cleaning Troubleshooting Tips
To Reset the Timer

If the display is still showing the time remaining, you may change it by touching the TIMER/CLOCK pad, then touching the

+or pad until the time you want appears in the display.

If the remaining time is not in the display (clock, start time or cooking time are in the display), recall the remaining time by touching the TIMER/CLOCK pad and then touching the + or pad to enter the new time you want.

Consumer

To Cancel the Timer

Touch the TIMER/CLOCK pad twice.

9

Support

Page 9
Image 9
GE JRP20 Using the clock and timer, Support, Consumer, Care and, Cleaning Troubleshooting Tips, To Set the Clock, Safety