GE JSP42 Care and cleaning of the range, Consumer Support, How to Remove Packaging Tape, To Order

Care and cleaning of the range. www.GEAppliances.com

Be sure all controls are off and all surfaces are cool before cleaning any part of the range.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device is reengaged properly when the range is replaced. Failure to take this precaution could result in tipping of the range and cause injury.

How to Remove Packaging Tape

To assure no damage is done to the finish	Apply with a soft cloth and allow to soak.
of the product, the safest way to remove	Wipe dry and then apply an appliance
adhesive left from packaging tape and	polish to thoroughly clean and protect
labels on new appliances is an application	the surface.
of a household liquid dishwashing	NOTE: The adhesive must be removed from all
detergent, mineral oil or cooking oil.
	parts. It cannot be removed if it is baked on.

Control Knobs

The control knobs may be removed for easier	the knobs, check the OFF position to
cleaning.	insure proper placement.
Before removing the knobs for	Wash the knobs in soap and water or
cleaning, please note that the knobs	a vinegar and hot water solution but
are in the OFF position. When replacing	do not soak.

Oven Vent

The oven vent is located above the left side of	It is normal for steam to come out of
the door.	the vent.
This area could become hot during	The vent is important for proper air circulation.
oven use.	Never block this vent.

Stainless Steel Surfaces (on some models)

Safety Instructions Operating Instructions Care and Cleaning

Do not use a steel-wool pad; it will scratch the surface.

Shake bottle well.

Place a small amount of CERAMA BRYTE® Stainless Steel Appliance Cleaner on a damp cloth or damp paper towel.

with dishwashing liquid and water prior to using the CERAMA BRYTE® Stainless Steel Appliance Cleaner. After washing the surface with dishwashing liquid and water, use a generous amount

of CERAMA BRYTE® Stainless Steel Appliance Cleaner to clean the appliance.

Troubleshooting Tips

Clean a small area (approximately 8″ x 8″), rubbing with the grain of the stainless steel if applicable.

Dry and buff with a clean, dry paper towel or soft cloth.

Repeat as necessary.

NOTE: If a mineral oil-based stainless steel appliance cleaner has been used before to clean the appliance, wash the surface

To Order

To order CERAMA BRYTE® Stainless Steel Appliance Cleaner, please call our toll-free number:

National Parts Center 800.626.2002

www.GEAppliances.com

CERAMA BRYTE®

Stainless Steel Appliance

Cleaner . . . . . . . . . . . . . . . . . . . .# PM10X311

Consumer Support

21