GE JTD915 Remove Packaging and Parts, Installation Below a Countertop, Instructions, Height 91⁄4″

Safety Instructions

Installation of the warming drawer.

Read these instructions completely and carefully.

Remove Packaging and Parts

Instructions

Parts provided: 4 Wood screws

Place carton on a flat surface.

Open one end of the carton and lift off the top piece.

Lift the warming drawer up and out of the carton.

Place the drawer on top of the shipping carton to protect the drawer front and the finished flooring.

Remove all packing materials and tape.

Locate package containing 4 wood screws and set aside.

Tips Installation Instructions Care and Cleaning Operating

Installation Below a Countertop

Install 2x4 or 2x2

Electrical outlet

Electrical outlet 42″ max.

″

11⁄2″ Cabinet top

anti-tip block against

flush with side of

from right side

25

rear cabinet wall 9”

cabinet 7″ max.

″

Install a solid barrier below

from floor to bottom

7

a cooktop (see Note)

of block

1″ Min.*

36″

9″

Countertop

height

Electrical

91⁄4″

outlet 16″ max.

from left side

Solid barrier

Dimension A

1/4” Air gap

231⁄2″ Min.

27 ″ Drawer

30 ″ Drawer

25 1⁄2 ″

28 1⁄2 ″

*NOTE: When installing the warming drawer below a cooktop,

Install a solid barrier

WARNING!

and a 1/4” min. air gap

a solid barrier must be installed at least 1″ from the lowest point

above warming drawer

of the bottom of cooktop burner box to the top of cutout. Use any

solid material such as 1/4″ thick plywood. Allow at least 1/4″ air

IN CANADA THIS DRAWER IS NOT

gap between the barrier and the top of the warming drawer. See

APPROVED FOR INSTALLATION

label on top of the warming drawer for approved cooktop models.

UNDER A COOKTOP.

Consumer Support Troubleshooting

■When installed, the front face of the warming drawer will be nearly flush with cabinetry doors or drawer fronts.

■Drawer overlaps will conceal cut edges on all sides of the opening.

The rough opening for the drawer must be:

—Depth:231⁄2″ minimum from inside back to front of cabinet frame.

—Width:251⁄2″ for 27″ wide models 281⁄2″ for 30″ wide models.

—Height: 91⁄4″

■5″ minimum above floor or 1″ above toekick. 231⁄4″ from floor to bottom of cutout is recommended for under countertop installation.

12

Installation below a cabinet drawer:

The warming drawer may be installed beneath a cabinet drawer. In this installation, a solid barrier should be installed above the warming drawer to block access. Use any solid material such as 1/4″ thick plywood. Allow at least 1/4″ air gap between the barrier and the top of the warming drawer. Observe the 5″ min. above the floor or 1″ above the toekick min. installation height.

NOTE: If you are installing in frameless cabinets, it may be necessary to install 1/2″ wide cleats to accept drawer mounting screws. See drawer to find exact locations of mounting screws.

When installed under a cooktop:

Warming drawers are suitable for installation below only certain specified cooktop models. See the label attached to the top of the warming drawer for suitable models. A solid barrier and air gap between cooktop and warming drawer is required. See Note above.