GE JVM1665SNSS warranty C4. MOUNT THE OVEN, C3. ADAPTING BLOWER FOR RECIRCULATION continued

Installation Instructions

C3. ADAPTING BLOWER FOR RECIRCULATION (continued)

5Place the blower unit back into the opening.

CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.

6Replace blower plate and replace screws for blower plate and blower motor removed in Step 1.

Blower Plate Screws

Blower Plate

Back of Oven

NOTE: When mounting the oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1–3. Do not pinch cord or lift oven by pulling cord.

2Rotate front of oven up against cabinet bottom.

1

Lift oven, tilt it forward and hook slots at back bottom edge onto two lower tabs of mounting plate.

Blower Motor Screw

C4. MOUNT THE OVEN

FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN.

IMPORTANT: Do not grip or use handle during installation.

NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.

NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.

IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws.

Cabinet Front

Cabinet Bottom Shelf

Filler Block

Equivalent to Depth of Cabinet Recess

Self-Aligning Screw

Oven Top

21