Installation Instructions
B5. ADAPTING BLOWER FOR OUTSIDE BACK EXHAUST
1Remove the two screws that hold the blower plate and remove the screw holding the blower motor to the oven. Slide blower plate from under its retaining flange.
Retaining |
|
Flange | Blower Plate |
|
2Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.
BEFORE: Fan Blade
Openings Facing Up
Back
of Oven
3Rotate blower unit counterclockwise 180°.
Before Rotation | After Rotation |
Back of | Back of | |
Oven | ||
Oven | ||
|
4Roll the blower unit 90° so that fan blade openings are facing out the back of the oven.
Before Rolling | After Rolling |
Back of | Back of |
Oven | Oven |
5 Place the blower unit back into the opening.
AFTER: Fan
Blade Openings
Facing Back
CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should match exhaust openings on rear of oven.
6Replace the blower plate in the same position as before and replace the screws for the blower plate and blower motor.
Blower Plate Screws
Blower Plate
Back of Oven
Blower Motor Screw |
17