GE JVM172H warranty Grounding Instructions, Cooktop Light/Night Light, Oven Light

Cooktop Light/Night Light

REMOVE SCREW

To replace combination cooktop light/night light, first disconnect power at main fuse or circuit breaker panel or pull plug.

With smoke & spatter shield in the OUT position, remove screw on right side of light compartment cover and lower cover until it stops.

I

Be sure bulbs to be replaced are cool before removing. Break the adhesive seal by gently unscrewing the bulbs. Replace with 40-watt incandescent bulbs (WB2X4253) available from your GE supplier. High intensity 40-watt bulbs (40SllN/1) which are available in supermarkets and hardware stores may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Oven Light

To replace your oven light, first disconnect power at main fuse or circuit breaker or pull plug.

Remove the top grill by taking out 3 screws that hold it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with a 30-watt GE bulb (WB2X4235) available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a warm detergent solution. About 1 tablespoon of ammonia may be added to the water providing it does not touch the filters or enameled surfaces because ammonia tends to darken metal. Wash the smoke

&spatter shield with a warm detergent solution.

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1)

WARNING-improper

use of the grounding plug can result in a risk of electric shock.

	INSURE PROPER
	GROUND EXISTS
Fig. 1	BEFORE USE

Consult a qualified electrician or service technician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.

Where a standard two-prong wall receptacle is encountered, it is your personal responsibility and obligation to have it replaced with

aproperly grounded three-prong wall receptacle.

Do not under any circumstance cut or remove the third (ground) prong from the power cord.

Do not use an adapter plug with this appliance.

Do not use an extension cord with this appliance.

29