Next, remove the screw located above the door near the center of the oven that secures the light housing.
Remove the bulb from the light housing by pulling straight out. Replace with the same size and type bulb, then replace the light housing.
To replace the oven light, first disconnect the power at the main fuse or circuit breaker panel or pull the plug.
To replace the bulb(s), first disconnect the power at the main fuse or circuit breaker panel or pull the plug.

Replacing the light bulbs.

www.GEAppliances.com

Safety

Remove screw

Cooktop Light/Night Light

On models JVM1850 and JVM1851, replace the burned-out bulb with a 40-watt incandescent bulb (WB36X10003), available from your GE supplier.

On models JVM1860, JVM1861 and JVM1870 replace the burned-out bulb with a 120 volt, 20-watt halogen bulb (WB36X10213), available from your GE supplier.

1

2 Remove the screw at the right edge of the light cover and push on the left edge of the cover to open.

3 Be sure the bulb(s) to be replaced are cool before removing. After breaking the adhesive seal, remove the bulb by either gently turning (for models JVM1850 and JVM1851) or pulling straight out (for models JVM1860, JVM1861 and JVM1870). Replace with the same size and type bulb.

4 Raise the light shield and replace the screw. Connect electrical power to the oven.

Oven Light

Replace the burned-out bulb with a 120 volt, 20-watt halogen bulb (WB36X10213), available from your GE supplier.

1

2 Remove the top grille by taking out the screws on top of the grille that hold it in place and sliding the grille to the left (opening the door makes grille removal easier).

3

4

5 Replace the grille and screws. Connect electrical power to the oven.

Instructions

Operating Instructions

Troubleshooting Tips

Consumer Support

35

Page 35
Image 35
GE JVM1860SS owner manual Replacing the light bulbs, Cooktop Light/Night Light, Oven Light