GE JVM250AV, JVM250WV, JVM250BV manual Light Bulb Replacement, Cooktop Light/Night Light, Oven Light

LIGHT BULB REPLACEMENT

Cooktop Light/Night Light

To replace combination cooktop/night light, first disconnect power at main

fuse or circuit

breaker panel or pull plug. REMOVE SCREW

Remove screw on right side of light compartment cover and lower cover until it stops.

Be sure bulbs to

be replaced are cool before removing. Break the adhesive seal by gently unscrewing

the bulbs. Replace with 40-watt

incandescent bulbs (WB02X4253) available from your GE supplier. High intensity 40-watt bulbs (40S11N/1), which are available in supermarkets and hardware stores, may also be used for replacements. Raise light compartment cover and replace screw. Connect electrical power to microwave oven.

Oven Light

To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold it in place.

Next, remove the single screw located above door near center of oven that secures light housing. Replace burned-out bulb with

a 30-watt incandescent bulb (WB02X4235), available from your GE supplier.

Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia may be added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal.

30