gGE Security
| OTHER KEYPAD FUNCTIONS |
Setting the keypad tone | |
Step 1 | Press the [r] key. |
Step 2 | Press the [0] key. Keypad is now in the “Adjust Tone” mode. |
Step 3 | Pressing the [1] key will make the keypad sounder go to higher tones, pressing the [2] key will |
| make the keypad sounder go to lower tones. |
Step 4 | When the desired tone is reached, press the [#] key to set this tone and exit |
| from the “Adjust Tone” mode. |
Change partition (optional) | |
Step 1 | Press the [r] key. |
Step 2 | Press the [1] key. |
Step 3 | Press a NUMBER key between 1 and 8 to change partitions momentarily. |
Step 4 | If no other key is pressed, it will go back to its standard partition in ten seconds. |
Step 5 | If another key is pressed, the system will remain in the new partition until no keys have been |
| pressed for 60 seconds. |
View alarm memory | |
Step 1 | Press the [r] key. |
Step 2 | Press the [3] key to display the zone(s) on the keypad that created the last alarm. |
Step 3 | The ALARM MEMORY feature will flash those zones that created alarms and will light steady |
| those zones that were bypassed during the last alarm. |
Test function (optional)
If programmed, this function will perform a battery test, communicator test, and/or a siren test.
Step 1 | Press [r] [4] [4]. The test will be performed as programmed. |
Step 2 | If the siren test is performed, enter a user code to silence the siren. |
No alarms will be sent and no reports will be sent unless a communicator test is performed, at which time a test signal will be sent.
Page 13 | 04/10/04 |
