Installation Instructions
D. ALIGNING THE WALL PLATE
| Hole B |
Hole A | Draw a Vertical |
| Line on Wall |
| from Center of |
| Top Cabinet |
Hole C
Area E
CAUTION: Wear gloves to avoid cutting fingers on sharp edges.
1Draw a vertical line on the wall at the center of the 30″ wide space.
2Use the mounting plate as the template for the rear wall. Place the mounting plate on the wall, making sure that the tabs are touching the bottom of the cabinet. Line up the notch and center line on
the mounting plate to the center line on the wall.
3While holding the mounting plate with one hand, draw circles on the wall at holes A, B, C and D (see illustration above/actual plate marked with arrows). Four holes must be used for mounting.
Hole D
NOTE: Holes C and D are inside area E. If neither C nor D is in a stud, find a stud somewhere in area E and draw a fifth circle to line up with the stud. It is important to use at least one wood screw mounted firmly in a stud to support the weight of the microwave.
Set the mounting plate aside.
4Drill holes on the circles. If there is a stud, drill a 3⁄16″ hole for wood screws. For holes that don’t line up with a stud, drill a 5⁄8″ hole for toggle bolts.
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
10
