Installation Instructions
B1. PREPARING THE REAR WALL FOR OUTSIDE BACK EXHAUST
(continued)
House | Damper Hinge On Top |
Duct |
|
Damper Swings Free 
9Fit the exhaust adaptor into the house duct as shown. Make sure the exhaust adaptor (with the damper) is squared up in the house duct and lines up with the holes in the mounting plate.
10 Remove the paper from the sticky side of the 28″ foam tape. Press the sticky side onto the face of the exhaust adaptor. (Don’t stretch the foam tape.)
Foam |
| |
Tabs | Mounting | |
Plate | ||
|
11Attach the other 28″ foam tape to the front of the mounting plate around both of the exhaust openings where it will touch the microwave.
B2. ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud.
1Remove the toggle wings from the bolts.
2Insert the bolts into the mounting plate through the holes designated to go into drywall and reattach the toggle wings to 3⁄4″ onto each bolt.
16
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Mounting | Toggle Wings | |
Toggle | ||
Plate | ||
Bolt | ||
|
Wall
Bolt End
3Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall.
4Tighten all bolts. Pull the plate away from the wall to help tighten the bolts.
B3. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and a hole large enough for the power cord to fit through.
•Read the instructions on the TOP CABINET TEMPLATE.
•Tape it underneath the top cabinet.
•Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes in the cabinet bottom.
