Installation Instructions
B4. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST
1Remove and save screw that holds blower motor to microwave.
Blower Motor
Back of
Microwave
Blower Motor
Screw
2Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit.
BEFORE: Fan Blade | End B | |
Openings Facing Up | ||
|
End A
3Rotate blower unit counterclockwise 180°.
Before Rotation | After Rotation |
Back of | Back of |
Microwave | Microwave |
4Gently remove the wires from the grooves. Reroute the wires through grooves on other side of the blower unit.
Before Rerouting | After Rerouting |
Wires Routed Through Right Side | Wires Routed Through Left Side |
5Roll the blower unit 90° so that fan blade openings are facing out the back of the microwave.
Before Rolling | After Rolling |
Back of | Back of |
Microwave | |
Microwave |
|
6Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End A
End B
CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven.
7Secure the blower unit to the microwave with the screw from Step 1.
Blower Plate
Back of
Microwave
Blower Motor
Screw
8Replace the blower plate in the same position as before with the screw.
17