GE JSP39SNSS, Quickset III, Quickset IV Using the oven control, clock, and timer features and settings

	Using the oven control, clock
	and timer features and settings.			GEAppliances.com
Throughout this manual, features and appearance may vary from your model.
		Bake/Temp Recall Pad		Clock Pad
	Bake	Touch this pad to select the bake function.	Clock	To set the clock, press this pad
	Temp Recall	Bake Light		twice and then press the + and –
		Flashes while in edit mode—you can change the oven		pads. The time of day will flash in
		temperature at this point. Glows when the oven is in		the display when the oven is first
		bake mode.		turned on.

Instructions Safety

Kitchen

Timer

On/Off

Start/On Pad

Must be touched to start any cooking or cleaning function.

Display

Shows the time of day, oven temperature and the times set for the timer or automatic oven operations. The display will show PrE while preheating. When the oven reaches the selected temperature, the oven control will beep and the display will show the oven temperature.

If “F–” and a number or letter flash in the display and the oven control signals, this indicates a function error code.

If your oven was set for a timed oven operation and a power outage occurred, the clock and all programmed functions must be reset.

The time of day will flash in the display when there has been a power outage. Reset the clock.

If the function error code appears during the self- cleaning cycle, check the oven door latch. The latch handle may have been moved, even if only slightly, from the latched position. Make sure the latch is moved to the right as far as it will go.

Touch the Clear/Off pad. Allow the oven to cool for one hour. Put the oven back into operation. If the function error code repeats, disconnect the power to the range and call for service.

Display On/Off

To save energy, you can turn off the time of day clock and the display when the range is not in use. Touch and hold the + and – pads at the same time to enable or disable this feature. This will turn the display on or off. NOTE: The display will remain off after a power outage.

Kitchen Timer On/Off or Timer On/Off Pad

Touch this pad to select the timer feature. Then press + and – pads to adjust time.

Timer Light

Flashes while in edit mode—you can change the set time at this point. Glows when the timer has been activated. Flashes again when the time has run out until the control is reset.

Start Time Pad

Start	Use along with the Cooking Time
Time
	or Self Clean pads to set the oven
	to start and stop automatically
	at a time you set.

Start Time Light

Flashes while in edit mode—you can change the start time at this point. Glows when the function has been activated.

	Cooking Time Pad
Cooking	Touch this pad and then touch the
Time	+ or – pads to set the amount of
	time you want your food to cook.
	The oven will shut off when the
	cooking time has run out.

Cooking Time Light

Flashes while in edit mode—you can change the set time at this point. Glows when the function has been activated. Flashes again when the time has run out until the control is reset.

Automatic Oven Light

This lights anytime the oven has been programmed using the Cooking Time or Start Timefunctions.

	Oven Light On/Off Pad
Oven
	Touch this pad to turn the oven light
Light
On/Off	on or off.

– Pad

Short taps to this pad will decrease the time or temperature by small amounts. Touch and hold the pad to decrease the time or temperature by larger amounts.

+ Pad

Short taps to this pad will increase the time or temperature by small amounts. Touch and hold the pad to increase the time or temperature by larger amounts.

11

Instructions Operating

Support Consumer Tips Troubleshooting Cleaning and Care