Data out of range | GE RPT 301 guide

16	RPT 301 User Manual

Error Message Format

The form of the error message:

ERROR nn - where nn is a decimal number

Defined error numbers are:

01	-	Bad command
02	-	Bad password
04	-	Bad data detected by checksum
08	-	Data out of range
16	-	Hardware fault
32	-	Pressure outside range
64	-	System not ready

Error messages are sent when an error is detected.

Example

When first detected the hardware fault error is sent once even though the fault persists, sending the S (status) command provides further details of the fault.

K177 Issue No. 3

Image 24

GE RPT 301 user manual Data out of range

Contents

RPT General Electric Company. All rights reserved RPT Digital Output Pressure Transducer K177 K177 Issue No Safety Abbreviations and Symbols Iii K177 Issue No Specification DimensionsDescription Accuracy Power supply Pressure measurementData Communications Pressure connection Accessories Mounting the Instrument Figure Pressure Connection Instrument Dimensions Electrical Connection Communication connections Connections for remote on/off control Communications Changing the communication interface standard Figure LK1 LK2 PL3PL1 RPT Screening Command Summary System Operation Command Function Measurement CR Crlf Command TerminatorsSet-up User calibration General Command Format Single commandsCommand Strings Page Error Message General Reply Format Data out of range Detailed Command Definitions Measurement Commands Return stored readingGet reading Auto send reading Auto Send from switch-on Set-up Commands Unit Set-up Command F, step, average Set ResolutionFilter Set-up Set Communications Options Command I,S/PIN, Name ValueCR format StatusIdentity Calibration Check User Calibration Linearity/Drift Compensation PIN Change PIN PIN, New PIN LED Indicator Diagnostic ModeDiagnostic Mode General Cleaning Approved Service Agents